Section 186 (Automatic Transmission Cooling System -- F150): Specifications
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC |
MERCON® LV | 12.30L (13.0 qt) |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Transmission Fluid This transmission fluid is not interchangeable with any other transmission fluids. Check the transmission fluid level indicator to determine the correct transmission fluid. |
|
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Axle carrier mounting bushing bolt | 115 | 85 | - | ||
| Axle shaft housing carrier bushing bolt | 115 | 85 | - | ||
| Forward skid plate (6 required) | 48 | 35 | - | ||
| Heat shield nut-Raptor | 48 | 35 | - | ||
| Heat shield nut-Raptor | 23 | 17 | - | ||
| Rearward skid plate (4 required) | 48 | 35 | - | ||
| Selector lever cable splash shield nut | 12 | - | 106 | ||
| Starter motor ground cable eyelet nut | 25 | 18 | - | ||
| Starter solenoid B-terminal eyelet nut | 12 | - | 106 | ||
| Starter solenoid S-terminal eyelet | 5 | - | 44 | ||
| Sway bar nut (4 required)(1) | - | - | - | ||
| Transmission fluid cooler tube bracket bolt | 12 | - | 106 | ||
| Transmission fluid cooler tube bracket-to-front of the engine nut-3.5L GTDI and 3.7L | 12 | - | 106 | ||
| Transmission fluid cooler tube bracket-to-front of the engine nut-5.0L (4V) | 12 | - | 106 | ||
| Transmission fluid cooler tube bracket-to-front of the engine nut-6.2L (2V) | 40 | 30 | - | ||
| Transmission fluid cooler tube bracket-to-starter motor stud nut-3.5L GTDI and 3.7L | 12 | - | 106 | ||
| Transmission fluid cooler tubes-to-transmission bolt (1) | - | - | - | ||
| Transmission-to-engine bolt-6.2L (2V) and 5.0L (4V) | 48 | 35 | - | ||
|
|||||