Transmission Fluid Cooler Tubes - 3.5L GTDI, 3.7L: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
If equipped, remove the 4 fasteners and the splash shield.

Fig 1: Locating Fasteners And Splash Shield
Courtesy of FORD MOTOR CO.
If equipped, remove the 12 pushpins and the air deflector.

Fig 2: Locating Pushpins And Air Deflector
Courtesy of FORD MOTOR CO.
If equipped, remove the 4 bolts and the skid plate.

Fig 3: Locating Bolts And Skid Plate
Courtesy of FORD MOTOR CO.
Remove the transmission fluid cooler tube secondary latches.

Fig 4: Locating Transmission Fluid Cooler Tube Secondary Latches
Courtesy of FORD MOTOR CO.
Using the Transmission Cooler Line Disconnect Tool, disconnect the transmission fluid cooler tubes from the transmission fluid cooler hoses.

Fig 5: Disconnecting Transmission Fluid Cooler Tubes From Transmission Fluid Cooler Hoses
Courtesy of FORD MOTOR CO.
Remove the transmission fluid cooler tube bracket nut from the front of the engine.

Fig 6: Locating Transmission Fluid Cooler Tube Bracket Nut
Courtesy of FORD MOTOR CO.
Remove the transmission fluid cooler tube bracket nut from the starter motor stud bolt.

Fig 7: Locating Transmission Fluid Cooler Tube Bracket Nut From Starter Motor Stud Bolt
Courtesy of FORD MOTOR CO.
If equipped, remove the selector lever cable splash shield nut and the selector lever cable splash shield.

Fig 8: Locating Selector Lever Cable Splash Shield Nut
Courtesy of FORD MOTOR CO.

NOTE: The transmission fluid cooler tube O-rings may remain in the transmission case. Carefully remove them from the case if retained.

Fig 9: Locating Transmission Fluid Cooler Tubes-To-Transmission Bolt

Courtesy of FORD MOTOR CO.

Remove and discard the transmission fluid cooler tubes-to-transmission bolt and separate the transmission fluid cooler tubes from the transmission.
Remove and discard the 4 O-rings on the transmission fluid cooler tubes.

Fig 10: Locating O-Rings On Transmission Fluid Cooler Tubes
Courtesy of FORD MOTOR CO.
Remove the transmission fluid cooler tubes from the transmission.