LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Engine Cooling System - F150) >> Removal And Installation >> Coolant Pump - 3.5L GTDI, 3.7L >> Removal

Coolant Pump - 3.5L GTDI, 3.7L: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet pipe. For additional information, REFER to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Loosen the 4 coolant pump pulley bolts.
  3. Remove the accessory drive belt. For additional information, REFER to ACCESSORY DRIVE .
    4. NOTE: Cover the A/C compressor belt to prevent coolant contamination of the belt.
  4. Completely cover the A/C compressor belt with waterproof plastic.
  5. Remove the thermostat housing. For additional information, refer to THERMOSTAT HOUSING - 3.5L GTDI  or THERMOSTAT HOUSING - 3.7L  .
  6. Remove the 4 bolts and the coolant pump pulley.
  7. Remove the 7 bolts and the coolant pump.
    • Remove and discard the gasket and the O-ring seal in the coolant pump.
scientia non olet · About LEMON Manuals