LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Mechanical - 6.8L (3V) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flexplate. For additional information, refer to Flexplate .
  2. Remove the engine rear cover plate.
  3. Using the Slide Hammer and the Crankshaft Rear Oil Slinger Remover, remove and discard the crankshaft oil slinger.
    Fig 1: Removing Crankshaft Oil Slinger
    G06126453Courtesy of FORD MOTOR CO.
  4. Using the Slide Hammer and the Crankshaft Rear Oil Seal Remover, remove and discard the crankshaft rear seal.
Fig 2: Removing Crankshaft Rear Seal
G06126454Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals