Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the Air Cleaner (ACL) outlet pipe. For additional information, REFER to INTAKE AIR DISTRIBUTION & FILTERING .
- Disconnect the Throttle Body (TB) electrical connector.
- Loosen the clamp and disconnect the Charge Air Cooler (CAC) outlet pipe-to-TB.
- To install, tighten to 5 Nm (44 lb-in).
- Remove the 4 bolts and the TB.
- Discard the TB gasket.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
NOTE:
Install a new TB gasket.