LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 179 (Fuel Charging System & Fuel Control System - 3.5L-GTDI - F150) >> Removal And Installation >> Fuel Injection Pump >> Removal

Fuel Injection Pump: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
WARNING: Clean all fuel residue from the engine compartment. If not removed, fuel residue may ignite when the engine is returned to operation. Failure to follow this instruction may result in serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
NOTE: Do not loosen any fittings or plugs on the fuel injection pump.
NOTE: Click here or refer to the on-line Workshop Information to view this illustration as an interactive exploded view, requires Adobe® Acrobat® 8.0 or higher.
NOTE: Click here or refer to the on-line Workshop Information to learn about using an Interactive Illustration.
  1. Release the fuel system pressure. For additional information, REFER to FUEL SYSTEM - GENERAL INFORMATION .
    2. NOTE: Use care when removing the fuel injection pump noise insulator. Spreading the openings will aid in removing the fuel injection pump noise insulator and reduce the risk of damage.
  2. Remove the fuel injection pump noise insulator shield.
  3. Disconnect the fuel injection pump electrical connector.
  4. Disconnect the fuel jumper tube-to-fuel injection pump quick connect coupling. For additional information, REFER to FUEL SYSTEM - GENERAL INFORMATION .
  5. Alternately loosen the 2 fuel injection pump bolts one complete revolution at a time.
scientia non olet · About LEMON Manuals