LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Engine Mechanical - 3.5L-GTDI - F150) >> In-Vehicle Repair >> Front Cover Radial Seal >> Installation

Front Cover Radial Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Water Tube Seal Installer, install the front cover radial seal.
    • Position the front cover radial seal on the Water Tube Seal Installer.
    • Position the Water Tube Seal Installer into the engine front cover.
    • Using a brass hammer, tap the Water Tube Seal Installer until the front cover radial seal bottoms out.
      Fig 1: Installing Front Cover Radial Seal
      G07410361Courtesy of FORD MOTOR CO.
  2. Inspect the front cover radial seal for proper installation or damage.
  3. Install the coolant pump. For additional information, REFER to ENGINE COOLING .
  4. Install the accessory drive and A/C compressor belt. For additional information, REFER to ACCESSORY DRIVE .
scientia non olet · About LEMON Manuals