Exhaust Manifold - LH: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Install 8 new LH exhaust manifold studs.
- Tighten to 12 Nm (106 lb-in).

NOTE: Failure to tighten the exhaust manifold nuts to specification a second time will cause the exhaust manifold to develop an exhaust leak.

Using a new gasket, install the LH exhaust manifold and 8 new nuts. Tighten in 2 stages in the sequence shown in illustration:
- Stage 1: Tighten to 19 Nm (168 lb-in).
- Stage 2: Tighten to 25 Nm (18 lb-ft).
  
  Fig 1: Identifying LH Exhaust Manifold And Nuts Tightening Sequence
  Courtesy of FORD MOTOR CO.
Install the LH turbocharger. For additional information, REFER to FUEL CHARGING AND CONTROLS - TURBOCHARGER .