LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Engine Mechanical - 3.5L-GTDI - F150) >> In-Vehicle Repair >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
  2. Remove the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY  .
  3. Using the Oil Seal Remover, remove and discard the crankshaft front seal.
    • Clean all sealing surfaces with metal surface prep.
      Fig 1: Removing Crankshaft Front Seal
      G07410340Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals