LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Information System And Entertainment System - F150) >> Removal And Installation >> Tool Link™ Reader >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull back the carpet from the LH side of the passenger compartment rear interior wall.
    2. NOTE: Support the Tool Link™ reader while the 2 screws are being removed. Do not allow it to hang from the electrical connectors.
  2. Remove the 2 screws and the Tool Link™ reader.
    • Disconnect the electrical connectors.
    • If the Tool Link™ reader is being replaced, cut the power/ground feed from the vehicle electrical harness.
  3. To install, reverse the removal procedure.
    • If a new Tool Link™ is being installed, splice the new power/ground feed to the vehicle electrical harness.
scientia non olet · About LEMON Manuals