Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For vehicles with navigation, a splitter is built-in to the lower satellite radio antenna cable to split the satellite radio and Global Positioning System (GPS) signals.

Both cables

Lower the glove compartment completely.
Disconnect the upper-to-lower satellite radio antenna cable connection.
Upper cable
Remove the RH A-pillar trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
Remove the 3 screws, the RH sun visor retaining clip, and the RH sun visor.
- If equipped, disconnect the electrical connector.
Lower the front of the headliner enough to gain access to the satellite radio antenna electrical connector.
Remove the upper satellite radio antenna cable.
- Disconnect the electrical connector.
- Separate the pushpins from the A-pillar and instrument panel.
Lower cable
Remove the Audio Front Control Module (ACM). For additional information, refer to AUDIO CONTROL MODULE (ACM) .
Remove the lower satellite radio antenna cable.
- Disconnect the electrical connector.
- Separate the pushpins from the instrument panel.
Both cables
To install, reverse the removal procedure.