LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Information System And Entertainment System - F150) >> Removal And Installation >> Antenna - Satellite Radio >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies to both the stand-alone satellite radio antenna and the combination satellite radio/Global Positioning System (GPS) antenna.
  1. Remove the RH A-pillar trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the 3 screws, the RH sun visor retaining clip, and the RH sun visor.
    • If equipped, disconnect the electrical connector.
  3. Lower the front of the headliner enough to gain access to the satellite radio antenna electrical connector.
    4. NOTE: Remove the satellite antenna and pigtail through the mounting opening in the roof panel.
  4. Remove the satellite antenna.
    • Disconnect the electrical connector.
    • Remove the satellite antenna retaining bolt and retainer then remove the satellite antenna from the roof panel.
      • To install, tighten to 5 Nm (44 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals