Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wiper pivot arm.
1. Position the wiper pivot arm upward.
2. NOTE: During installation, it is necessary to pull the locking tab out to its full open (unlatched) position and hold while assembling the pivot arm onto the mounting arm and pivot shaft.
Pull outward on the retaining tab and remove the wiper pivot arm.

Fig 1: Removing Wiper Pivot Arm
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

If necessary, align the wiper blade and pivot arm. For additional information, refer to Wiper Blade and Pivot Arm Adjustment .