LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Wiper System & Washer System - F150) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl panel grille. For additional information, REFER to FRONT END BODY PANELS .
  2. Remove the 3 wiper mounting arm and pivot shaft bolts.
    • To tighten, tighten to 8 Nm (71 lb-in).
  3. Disconnect the wiper motor electrical connector.
  4. Remove the wiper mounting and pivot shaft assembly.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals