Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
When servicing the washer pump, be careful not to damage the washer pump seal.
NOTE:
Do not operate the washer pump before filling the washer reservoir. Failure to do so may result in premature washer pump failure.
- Remove the RH headlamp assembly. For additional information, REFER to EXTERIOR LIGHTING .
- Drain the windshield washer reservoir.
- Disconnect the washer reservoir hose.
- Disconnect the washer pump electrical connector.
- Remove the washer pump.
- To install, reverse the removal procedure.