DTC Charts
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure type code. The failure type code provides information about specific fault conditions such as opens or shorts to ground. Continuous Memory Diagnostic Trouble Codes (CMDTCs) have an additional 2-character DTC status code suffix to assist in determining DTC history.
STEERING COLUMN CONTROL MODULE (SCCM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure | INSTALL a new multifunction switch. REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new SCCM. REFER to STEERING COLUMN SWITCHES . |
| B1051:09 | Front Washer Switch: Component Failure | INSTALL a new multifunction switch. REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new SCCM. REFER to STEERING COLUMN SWITCHES . |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test E . |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | GO to Pinpoint Test E . |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. REFER to Rain Sensor . CLEAR the DTCs. REPEAT the self-test. |
| B1131:02 | Wiper Motor Module: General Signal Failure | GO to Pinpoint Test B . |
| B1131:08 | Wiper Motor Module: Bus Signal/Message Failure | GO to Pinpoint Test B . |
| B12F7:09 | Single Wipe Switch: Component Failure | INSTALL a new multifunction switch. REFER to STEERING COLUMN SWITCHES . CLEAR the DTCs and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new SCCM. REFER to STEERING COLUMN SWITCHES . |
| All other DTCs | - | REFER to STEERING COLUMN SWITCHES . |