LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Automatic Transmission External Controls - F150) >> Removal And Installation >> Selector Lever Bezel >> Installation

Selector Lever Bezel: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical harness to the selector lever bezel.
    Fig 1: Identifying Electrical Harness And Selector Lever Bezel
    G07412510Courtesy of FORD MOTOR CO.
  2. Install the selector lever bezel onto the selector lever housing.
    Fig 2: Locating Tabs On Selector Lever Bezel
    G07412509Courtesy of FORD MOTOR CO.
  3. Connect the select shift and the Tow/Haul electrical connectors and install the selector lever knob.
  4. Install a new LH selector lever knob screw.
    Fig 3: Locating LH Selector Lever Knob Screw
    G07412495Courtesy of FORD MOTOR CO.
  5. Install a new RH selector lever knob screw.
    Fig 4: Locating RH Selector Lever Knob Screw
    G07412494Courtesy of FORD MOTOR CO.
  6. Install a new LH selector lever knob cover.
    Fig 5: Installing LH Selector Lever Knob Cover
    G07412498Courtesy of FORD MOTOR CO.
  7. Install a new RH selector lever knob cover.
    Fig 6: Installing RH Selector Lever Knob Cover
    G07412499Courtesy of FORD MOTOR CO.
  8. Connect and install the floor console upper finish panel.
    Fig 7: Identifying Floor Console Upper Finish Panel
    G07412500Courtesy of FORD MOTOR CO.
  9. Install the instrument panel to floor console finish panel.
    Fig 8: Locating Instrument Panel To Floor Console Finish Panel
    G07412490Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals