Symptom Chart - External Controls, Floor Shift

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

SYMPTOM CHART - EXTERNAL CONTROLS, FLOOR SHIFT

Condition	Possible Sources	Action
The Brake Shift Interlock Actuator (BSIA) system does not release/lock correctly	Circuitry Fuse(s): Body Control Module (BCM) 18 (10A) BSIA	GO to PINPOINT TEST E .
	Selector lever cable	VERIFY selector lever cable adjustment. REFER to SELECTOR LEVER CABLE ADJUSTMENT - FLOOR SHIFT .
The shift control is out of correct gear relationship	Selector lever cable and bracket Selector lever linkage	GO to PINPOINT TEST F .
Transmission Range (TR) indicator (PRNDL) does not correspond to the selected gear	Selector lever cable bracket	TIGHTEN bolts holding selector lever cable bracket. REFER to SELECTOR LEVER CABLE ADJUSTMENT - FLOOR SHIFT .
	Selector lever cable loose at the selector lever	SECURE selector lever cable. REFER to SELECTOR LEVER CABLE ADJUSTMENT - FLOOR SHIFT .
	Selector lever cable	VERIFY selector lever cable adjustment. REFER to SELECTOR LEVER CABLE ADJUSTMENT - FLOOR SHIFT .
TR indicator (PRNDL) does not illuminate	Instrument Panel Cluster (IPC) malfunction Circuitry	REFER to INSTRUMENT CLUSTER AND PANEL ILLUMINATION .
TR indicator (PRNDL) does not illuminate	TR sensor	CHECK for TR sensor DTCs. REFER to AUTOMATIC TRANSAXLE/TRANSMISSION - 6R80 .
The Tow/Haul switch does not operate correctly	Tow/Haul switch Tow/Haul switch not cycled during self-test Circuitry	GO to PINPOINT TEST G .
The Tow/Haul lamp is not operating correctly	IPC PCM Circuitry	REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES .
The SelectShift™ switch is not operating correctly	SelectShift™ switch PCM Circuitry	GO to PINPOINT TEST H .
Water enters inside the vehicle	Cable assembly grommet	SECURE grommet to floor panel. REFER to SELECTOR LEVER CABLE - FLOOR SHIFT .
Water enters inside the vehicle	Torn selector lever cable assembly grommet	INSTALL a new selector lever cable. REFER to SELECTOR LEVER CABLE - FLOOR SHIFT .
Excessive shift effort	Selector lever cable	INSTALL a new selector lever cable. REFER to SELECTOR LEVER CABLE - FLOOR SHIFT .
Excessive shift effort	Cable bracket	ADJUST cable. TIGHTEN cable bracket screws. REFER to SELECTOR LEVER CABLE - FLOOR SHIFT .
Selector lever will not shift from PARK	Selector lever cable	VERIFY selector lever cable adjustment. REFER to SELECTOR LEVER CABLE ADJUSTMENT - FLOOR SHIFT .
	Selector lever knob	INSTALL a new selector lever knob. REFER to SELECTOR LEVER KNOB .
	Broken selector lever cable	INSTALL a new selector lever cable. REFER to SELECTOR LEVER CABLE - FLOOR SHIFT .
	Brake Shift Interlock Actuator (BSIA) system failure	GO to PINPOINT TEST E .
Vehicle will not crank/start in park but will crank/start in neutral	Selector lever cable	VERIFY selector lever cable adjustment. REFER to SELECTOR LEVER CABLE ADJUSTMENT - FLOOR SHIFT .
	TR sensor	CHECK for TR sensor DTCs. REFER to AUTOMATIC TRANSAXLE/TRANSMISSION - 6R80 .