LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (HVAC - Climate Control System - F150) >> Removal And Installation >> In-Vehicle Temperature and Humidity Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 steering column cover screws and the steering column cover.
  2. Remove the 4 steering column cover reinforcement bolts.
  3. Detach the in-vehicle temperature sensor aspirator hose.
  4. Disconnect the in-vehicle temperature sensor electrical connector.
  5. Remove the in-vehicle temperature sensor.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals