Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If installing a new HVAC module, the new module must be configured for the vehicle. For additional information, REFER to MODULE CONFIGURATION .

With navigation system

Remove the upper instrument panel storage tray mat.
Remove the 2 upper instrument panel storage tray screws.
Disconnect the speaker electrical connector (if equipped).
Remove the upper instrument panel storage tray.
Disconnect the 2 HVAC module electrical connectors.
Vehicles without navigation system
Remove the center instrument panel finish panel. For additional information, REFER to INSTRUMENT PANEL AND CONSOLE .
All vehicles
Remove the 4 HVAC module screws.
Remove the HVAC module.
To install, reverse the removal procedure.