Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the shift lever knob, using the Transmission Fluid Pump Remover and the Slide Hammer.
- Remove the consolette.
- Pull the consolette upward to release the retaining clips.
- To install, reverse the removal procedure.
- Make sure to align the consolette retaining clips to the adjacent retaining clip holes.
NOTE:
Install a durable cloth between the Transmission Fluid Pump Remover and the shift lever shaft and knob, failure to do so may cause damage to the components.