Battery Tray
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery. For additional information, refer to Battery and Battery Tray - Exploded View .
- Disconnect the wire harness retainers from the battery tray and position the wire harness aside.
- Remove the 3 bolts from the battery tray and carefully position the battery tray aside to gain access to the washer reservoir electrical connector.
- To install, tighten to 17 Nm (150 lb-in).
- Disconnect the wire connector and washer hose from the washer bottle and remove the battery tray assembly.
- To install, reverse the removal procedure.