LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Engine Controls - Electronic Engine Controls - F150) >> Removal And Installation >> Manifold Absolute Pressure (MAP)/Intake Air Temperature 2 (IAT2) Sensor - 3.5L GTDI >> Installation

Manifold Absolute Pressure (MAP)/Intake Air Temperature 2 (IAT2) Sensor - 3.5L GTDI: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the MAP/IAT2 sensor O-ring seal with clean engine oil.
  2. Install the MAP/IAT2 sensor and the bolt.
    • Tighten to 6 Nm (53 lb-in).
  3. Connect the MAP/IAT2 sensor electrical connector.
scientia non olet · About LEMON Manuals