LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Engine Controls - Electronic Engine Controls - F150) >> Removal And Installation >> Intake Air Temperature (IAT) Sensor - 3.5L GTDI >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Intake Air Temperature (IAT) sensor electrical connector.
  2. Remove the 2 screws and the IAT sensor.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals