LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Engine Controls - Electronic Engine Controls - F150) >> Removal And Installation >> Crankshaft Position (CKP) Sensor - 5.0L (4V) >> Installation

Crankshaft Position (CKP) Sensor - 5.0L (4V): Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The Crankshaft Position (CKP) sensor bolt is part of the CKP sensor and cannot be removed.
  1. Position the CKP sensor and tighten the bolt.
    • Tighten to 10 Nm (89 lb-in).
  2. Connect the CKP sensor electrical connector.
  3. Connect the CHT sensor electrical connector.
  4. Install the intake manifold. For additional Information, REFER to ENGINE - 5.0L (4V) .
scientia non olet · About LEMON Manuals