LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Steering Column - F150) >> Removal And Installation >> Steering Column Shroud >> Installation

Steering Column Shroud: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lower steering column shroud and install the 3 screws.
    • Tighten to 2 Nm (18 lb-in).
  2. Position the upper steering column shroud onto the lower steering column shroud and secure the front clips.
    3. NOTE: Use care and follow the installation sequence when installing the selector lever boot to the steering column shrouds or damage to the boot may occur causing replacement of the selector lever assembly. The selector lever boot is not serviceable separately.
  3. Install the selector lever boot in the sequence shown in illustration.
    1. Slide the front of the selector lever boot into position.
    2. Slide the bottom of the selector lever boot into position.
    3. Slide the top of the selector lever boot into position and push down.
    4. Push down on the back of the selector lever boot until selector lever boot is fully seated.
      Fig 1: Identifying Selector Lever Boot Installing Sequence
      G07410268Courtesy of FORD MOTOR CO.
  4. Place transmission selector lever in PARK.
  5. Release the parking brake.
  6. Position the steering column opening trim panel and install the 3 screws.
scientia non olet · About LEMON Manuals