LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Handles, Locks, Latches And Entry Systems - F150) >> Removal And Installation >> Tailgate Latch Remote Control >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, remove the tailgate step assist handle. For additional information, REFER to PICKUP BED AND PLATFORM BODY .
  2. Remove the bolts and the tailgate access panel (7 bolts for flareside bed, 8 for without step tailgate, or 13 with step tailgate).
    • To install, tighten to 5 Nm (44 lb-in).
  3. Open the 2 clips and release the 2 tailgate latch actuating rods from the tailgate remote control.
  4. If equipped, release the tailgate latch actuating rod locator from the tailgate.
  5. Remove the 2 tailgate release handle nuts and the tailgate remote control.
    • To install, tighten to 9 Nm (80 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals