Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear window regulator and motor. For additional information, REFER to GLASS, FRAMES AND MECHANISMS .
Disconnect the rear door latch electrical connector.
Open the clip and disconnect the exterior rear door handle actuating rod.

Fig 1: Locating Exterior Front Door Handle Actuating Rod Clip
Courtesy of FORD MOTOR CO.
Remove the 3 door latch bolts and remove the latch.
- To install, tighten to 12 Nm (106 lb-in).
To install, reverse the removal procedure.