LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Handles, Locks, Latches And Entry Systems - F150) >> Removal And Installation >> Rear Door Latch - Lower, SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the water shield aside.
  3. Disconnect the door ajar switch electrical connector.
  4. Disconnect the lower door latch actuating cable from the interior door handle.
  5. Remove the interior door handle actuating cable from the guide clips.
  6. Remove the 3 lower door latch bolts and the lower door latch.
    • To install, tighten to 12 Nm (106 lb-in).
  7. To install, reverse the removal procedure.