LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Handles, Locks, Latches And Entry Systems - F150) >> Removal And Installation >> Pickup Bed Side Step Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
  2. Open the step to the full extended position.
  3. Remove the 2 step cover screws.
  4. Slide the step cover off the step.
  5. Remove the 4 latch nuts and the latch.
    • To install, tighten to 9 Nm (80 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals