Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 hood latch bolts and position the hood latch aside.
- To install, tighten to 35 Nm (26 lb-ft).
- Disconnect the primary hood latch release cable.
- Disconnect the secondary hood latch release cable.
- Remove the hood latch.
- To install, reverse the removal procedure.
- When the hood latch is installed, the latch adjustment must be checked to make sure the latch is installed and aligned correctly.
NOTE:
Mark the location of the hood latch with a permanent-type marker.