LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Handles, Locks, Latches And Entry Systems - F150) >> Removal And Installation >> Hood Latch Release Handle - Primary >> Primary Hood Latch Release Cable Routing >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood latch. For additional information, refer to Hood Latch  .
  2. Remove the air cleaner element. For additional information, REFER to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Remove the degas bottle bolts and position the degas bottle assembly aside.
  4. Remove the cowl side trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
  5. Remove the primary hood latch release handle bolt.
    • To install, tighten to 9 Nm (80 lb-in).
  6. Release the cable locators and remove the primary hood latch release cable.
  7. To install, reverse the removal procedure.
    • When the hood latch is installed, the latch adjustment must be checked to make sure the latch is installed and aligned correctly.
scientia non olet · About LEMON Manuals