Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
40 percent and 60 percent rear seat cushion latches are removed in the same manor.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, SUPERCAB
.
- Remove the rear seat. For additional information, refer to SEAT - REAR, SUPERCAB .
- Remove the cushion pivot bolt.
- To install, tighten to 33 Nm (24 lb-ft).
- Remove the rear screw from the outboard riser.
- Separate the cushion from the inboard riser to avoid pivot bushing damage.
- To install, tighten to 6 Nm (53 lb-in).
- Remove the rear latch bolt and outboard seat riser.
- To install, tighten to 24 Nm (18 lb-ft).
- Remove the screw and latch bolt cover.
- Remove the front latch bolt and cushion latch.
- To install, tighten to 32 Nm (24 lb-ft).
- To install, reverse the removal procedure.