Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, CREW CAB .

Remove the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - REAR, CREW CAB .
Remove the 2 screws and latch release handle.
- Release the cable retainer.
- Note cable routing for correct installation.
For 60 percent seat, detach the assist spring strut from the outboard riser.

Fig 1: Detaching Assist Spring Strut From Outboard Riser
Courtesy of FORD MOTOR CO.
Remove the front and rear latch bolts.
- To install, tighten to 32 Nm (24 lb-ft).
Remove the cushion pivot bolt, outboard riser and cushion latch.
- To install, tighten to 32 Nm (24 lb-ft).
To install, reverse the removal procedure.