Seat Cushion Heater Mat - Rear: Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Install the cushion foam pad.
- Install the heater mat to the foam pad.
- Align the heater mat square to the seat with the wiring toward the rear edge and tuck the narrow areas into the valley of the foam pad.
- Align the windows of the heater mat over the listing wire in the foam pad to allow for hog ring installation when the cushion cover is installed.
- Firmly apply the heater mat to the foam pad and rub to seal the adhesive.
- Route the wire harness through the hole in the foam pad and connect the electrical connector.
- Install the seat cushion cover. For additional information, refer to SEAT CUSHION COVER - FRONT .
NOTE:
Remove the paper strip covering the adhesive before adhering the heater mat to the foam pad. Otherwise, damage to the seat can occur.
NOTE:
When adhering the heater mat to the foam pad, be sure to position the heater mat so it is straight and free of any wrinkles that may show through the cover material after installation.