Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
40 percent and 60 percent rear seat cushion covers are removed in the same manor.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, SUPERCAB
.
- Remove the rear seat cushion. For additional information, refer to SEAT - REAR, SUPERCAB .
- Release the cushion cover J-clip.
- Invert the cushion cover to the row of hog rings.
- Remove the hog rings.
- Invert and remove the cushion cover.
- If needed, separate and remove foam pad from the cushion frame.
- To install, reverse the removal procedure.
NOTE:
Use care when separating the seat cushion cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.