Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT .

If equipped, remove the adjustable lumbar knob.
- Adjust the lumbar until fully relaxed.
- Release the retainer and remove the knob.
Remove the side shield insert.
- Release the lower retainers and lift to release the upper retainers.
- Disconnect the seat control switch electrical connector.
- If equipped, disconnect the memory SET switch electrical connector.
Remove the seat control switch button.
If equipped, remove the recliner switch button.
Release the retaining tabs and remove switch.
To install, reverse the removal procedure.