Seat Backrest Heater Mat - Rear: Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Install the backrest foam pad to the backrest frame.
- Install the heater mat to the foam pad.
- Align the heater mat square to the seat with the wiring toward the lower edge and tuck the narrow areas into the valley of the foam pad.
- Align the upper windows of the heater mat over the listing wire in the foam pad to allow for hog ring installation when the backrest cover is installed.
- Firmly apply the heater mat to the foam pad and rub to seal the adhesive.
- Route the wire harness through the hole in the foam pad, attach and connect the electrical connector.
- Install the seat backrest cover. For additional information, refer to SEAT BACKREST COVER - FRONT
.
- For 40 percent seat, connect the cushion heater mat electrical connector.
NOTE:
Remove the paper strip covering the adhesive before adhering the heater mat to the foam pad. Otherwise, damage to the seat can occur.
NOTE:
When adhering the heater mat to the foam pad, be sure to position the heater mat so it is straight and free of any wrinkles that may show through the cover material after installation.