Seat Backrest Heater Mat - Front: Removal
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The heater mat is not designed to be separated from the foam pad. Doing so will damage the foam pad. Install a new foam pad and heater mat. Failure to follow this instruction can result in seat component damage and system failure.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT
.
- Remove the seat backrest cover. For additional information, refer to SEAT BACKREST COVER - FRONT .
- Disconnect the backrest heater mat electrical connector and detach the wiring harness.
- Note wire harness routing for correct installation.
- Remove the backrest foam pad with heater mat and discard.