LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Seat System - F150) >> Removal And Installation >> Seat Backrest Cover - Rear, Crew Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, CREW CAB  .
  1. Remove the seat. For additional information, refer to SEAT - REAR, CREW CAB, 40 PERCENT  or SEAT - REAR, CREW CAB, 60 PERCENT  .
  2. For 60 percent seat, remove the backrest. For additional information, refer to SEAT BACKREST - REAR, CREW CAB  .
    NOTE: 60 percent seat has 4 head restraint guides. 40 percent seat 2 head restraint guides.
  3. Remove and discard the head restraint guides. For additional information, refer to HEAD RESTRAINT GUIDE SLEEVE  .
  4. If equipped, remove the armrest. For additional information, refer to SEAT ARMREST - REAR, CREW CAB  .
  5. Release the lower J-clip.
    • If 40 percent seat equipped with heat, disconnect the cushion heater mat electrical connector.
    6. NOTE: Use care when separating the backrest cover from the hook-and-loop strip or the hook-and-loop strip can be torn from the foam pad.
  6. Partially invert the backrest cover.
    • For 60 percent seat, release the center J-clip(s) and armrest cavity retainers, if equipped.
  7. Remove all the hog rings attaching the backrest cover to the foam pad.
    • If needed, remove the hog rings attaching the foam pad to the backrest frame and disconnect the backrest heater mat electrical connector (if equipped).
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals