LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Seat System - F150) >> Removal And Installation >> Seat - Rear, Crew Cab, 40 Percent >> Installation

Seat - Rear, Crew Cab, 40 Percent: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
  1. Position the seat in the vehicle and raise the backrest and cushion but do not latch the backrest at this time.
  2. Install the 2 seat connecting bolts.
    • Tighten to 12 Nm (106 lb-in).
  3. Install the outboard front seat bolt.
    • Tighten to 47 Nm (35 lb-ft).
  4. Install the inboard front seat bolt.
    • Tighten to 47 Nm (35 lb-ft).
  5. Lower the cushion and backrest and install the 2 rear seat nuts.
    • Tighten to 80 Nm (59 lb-ft).
  6. If equipped with heated seats, connect the electrical connector.
  7. Raise and latch the backrest.
    • Slide the striker pin up/down and align to the backrest latch.
    • Make sure the backrest is fully latched.
  8. Install the safety belt buckle bolt cover.
scientia non olet · About LEMON Manuals