LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Seat System - F150) >> Removal And Installation >> Seat - Front >> Installation

Seat - Front: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Make sure the front passenger seat is correctly installed and fastened to the vehicle. Do not force the alignment to the floorpan mounting holes. If the seat does not align to the floorpan mounting holes, repair the seat or floorpan as needed. Failure to follow these instructions may result in incorrect operation of the occupant classification system (OCS) and increase the risk of serious personal injury or death in a crash.

All vehicles 

    NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
  1. Position the seat in the vehicle and connect the seat to body wire harness electrical connector(s).
    • Make sure the upper spacer is correctly positioned between the pedestal and seat at the rear inboard mount.
  2. Install the 2 front mounting bolts and tighten in the following sequence:
    1. If manual seat track, make sure the seat track rails are in sync and locked for correct mounting alignment.
    2. Tighten the front seat mounting bolt on the inboard side.
      • Tighten to 55 Nm (41 lb-ft).
    3. Tighten the front seat mounting bolt on the outboard side.
      • Tighten to 55 Nm (41 lb-ft).

    Regular cab and Crew Cab 

  3. Install the safety belt anchor and bolt.
    • Tighten to 40 Nm (30 lb-ft).
    • If passenger seat, connect the BTS electrical connector.
  4. Install the safety belt anchor cover.
  5. If equipped, install the manual recline handle and retainer.

    All vehicles 

  6. Repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
  7. Position the seat forward and install the 2 rear seat mounting bolts and covers.
    • Tighten to 55 Nm (41 lb-ft).
  8. For passenger seat, carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
scientia non olet · About LEMON Manuals