Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, FRONT
.
- Release the backrest cover J-clip and unzip the 2 zippers.
- If equipped, remove the backrest Thermo-Electric Device (TED). For additional information, refer to SEAT BACKREST THERMO-ELECTRIC DEVICE .
- Disconnect the lumbar motor electrical connector.
- Remove the lumbar assembly.
- Pinch the lumbar retainers together to release from the backrest frame.
- For installation, make sure the arrow is pointed up.
- To install, reverse the removal procedure.