Heated Seat Module - Rear: Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Install the heated seat module and screw.
- Tighten to 14 Nm (124 lb-in).
- Connect the 2 electrical connectors.
- Raise and latch the backrest.
- Slide the striker pin up/down and align to the backrest latch.
- Make sure the backrest is fully latched.
- Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
- Start the vehicle and push the low button on either heated seat switch.
- Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.