LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Seat System - F150) >> Disassembly And Assembly >> Seat Cushion - Rear, CrewCab >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, CREW CAB  .
  1. Remove the seat cushion latch. For additional information, refer to SEAT LATCH - REAR, CREW CAB  .
  2. Remove the cushion foam pad.
    • If equipped, disconnect the cushion heater mat electrical connector.
      • Note the wire harness routing for correct installation.
  3. Remove the assist spring strut.
  4. Remove the bolt and safety belt buckle.
    • To install, tighten to 32 Nm (24 lb-ft).
  5. Remove the screw and inboard side shield.
  6. Remove the inboard pivot bolt, inboard pedestal and cushion.
    • To install, tighten to 32 Nm (24 lb-ft).
  7. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals