Pinpoint Test Ai: DTC B19A6

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When taking measurements at Dual Climate Controlled Seat Module (DCSM) harness connectors, do not insert the electrical probes into the female connector pins. Inserting the probes into connector pins can cause intermittent or open electrical connections after reassembly resulting in Diagnostic Trouble Codes (DTCs) and system failure. Touching the tip of these connector pins is recommended instead.

NOTE: If a seat equipped with a seat mounted side air bag is being repaired, the Supplemental Restraint System (SRS) must be depowered. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .

NOTE: The air bag warning lamp illuminates when the Restraints Control Module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate an SRS fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

AI1 CHECK THE BACKREST TED BLOWER SPEED CONTROL CIRCUIT FOR A SHORT TO GROUND
- Ignition OFF.
- Depower the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
- Disconnect: Passenger Seat Side Air Bag Module C339.
- Disconnect: DCSM C3265C.
- Disconnect: Backrest TED C3039.
- Measure the resistance between DCSM C3265C-4, circuit VHS21 (BU/WH), harness side and ground.
  
  Fig 1: Measuring Resistance Between DCSM C3265C-4, Circuit VHS21 (BU/WH), Harness Side And Ground
  Courtesy of FORD MOTOR CO.
- Is the resistance greater than 10, 000 ohms?
  1. Yes : GO to AI2.
  2. No : REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test.
    CONNECT passenger seat side air bag module C339.
    
    REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
AI2 CHECK THE BACKREST TED BLOWER SPEED CONTROL CIRCUIT AND BLOWER GROUND CIRCUIT FOR A SHORT TOGETHER
- Measure the resistance between DCSM C3265C-4, circuit VHS21 (BU/WH), harness side and C3265C-7, circuit RHS08 (VT/WH), harness side.
  
  Fig 2: Measuring Resistance Between DCSM C3265C-4, Circuit VHS21 (BU/WH) And C3265C-7, Circuit RHS08 (VT/WH)
  Courtesy of FORD MOTOR CO.
- Is the resistance greater than 10, 000 ohms?
  1. Yes : INSTALL a new backrest TED. REFER to SEAT BACKREST THERMO-ELECTRIC DEVICE . CLEAR the DTCs. REPEAT the self-test.
    If the DTC is retrieved again, INSTALL a new DCSM. REFER to DUAL CLIMATE CONTROLLED SEAT MODULE (DCSM) . CLEAR the DTCs. REPEAT the self-test.
    
    DISCONNECT the battery ground cable.
    
    CONNECT passenger seat side air bag module C339.
    
    REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. No : REPAIR the circuits. CLEAR the DTCs. REPEAT the self-test.
    CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM .