LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Interior Trim And Ornamentation - F150) >> Removal And Installation >> Headliner - SuperCrew >> Installation

Headliner - SuperCrew: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the headliner in the vehicle so that the sun visor and coat hook openings are aligned.
  2. Install the LH and RH sun visors.
    • Reposition headliner and connect electrical connector.
    • Install the sun visor retainer screws.
    Fig 1: Locating Sun Visor Screws
    G06173126Courtesy of FORD MOTOR CO.
  3. Install the sun visor clip and sun visor clip screws.
    Fig 2: Locating Sun Visor Clip Screw
    G06173127Courtesy of FORD MOTOR CO.
  4. Install the garment hooks and garment hook screws.
    Fig 3: Locating Garment Hook Screw
    G06173125Courtesy of FORD MOTOR CO.
  5. Close the garment hook screw covers.
    Fig 4: Locating Garment Hook Screw Cover
    G06173124Courtesy of FORD MOTOR CO.
  6. If equipped with a roof opening panel, secure the hook-and-loop tape around the front edge of the roof opening panel and then secure the back edge of the roof opening panel so that it is flush and the headliner does not sag. If sagging occurs, loosen the sun visors and coat hooks to realign the headliner. Retighten the sunvisors and coat hooks.
  7. Install the headliner pin-type retainers.
    Fig 5: Locating Headliner Pin-Type Retainers
    G06173153Courtesy of FORD MOTOR CO.
  8. Connect the headliner electrical connectors.
    Fig 6: Locating Headliner Electrical Connectors
    G06173129Courtesy of FORD MOTOR CO.
  9. If equipped, connect the mirror electrical connector and the rain sensor.
    Fig 7: Locating Mirror Electrical Connector And Rain Sensor
    G06462576Courtesy of FORD MOTOR CO.
  10. Install the overhead console. For additional information, REFER to INSTRUMENT PANEL AND CONSOLE .
  11. Install the A-pillar trim panel. For additional information, refer to A-Pillar Trim Panel  .
  12. Install the B-pillar trim panels. For additional information, refer to B-Pillar Trim Panel - SuperCrew  .
  13. Install the C-pillar trim panels. For additional information, refer to C-Pillar Trim Panel  .
  14. Install the floor console. For additional information, REFER to INSTRUMENT PANEL AND CONSOLE .
  15. Install the driver seat. For additional information, REFER to SEATING↓ .
  16. Install the front passenger seat. For additional information, REFER to SEATING .
scientia non olet · About LEMON Manuals