Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
- Disconnect the wheel speed sensor electrical connector.
- Detach the wheel speed sensor harness retainers and pushpin retainers.
- Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 15 Nm (133 lb-in).
- To install, reverse the removal procedure.