LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Anti-Lock Brake System And Stability Control - F-150) >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc. For additional information, REFER to FRONT DISC BRAKE .
    2. NOTE: The wheel speed sensor harness electrical connector is located in the engine compartment secured to the fender apron.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Detach the 2 wheel speed sensor harness pushpin retainers.
  4. Detach the wheel speed sensor harness retainer from the brake hose.
  5. Remove the wheel speed sensor harness bolt.
    • To install, tighten to 12 Nm (106 lb-in).
  6. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 17 Nm (150 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals