Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Turn the steering wheel 90 degrees to the left to access the brake pedal control switch screws.
- Remove the steering column shrouds. For additional information, REFER to STEERING COLUMN .
- Remove the screw.
- To install, tighten to 3 Nm (27 lb-in).
- Using a suitable tool (such as a pocket screwdriver), carefully disengage the control switch locking tabs one at a time, then remove the switch.
- To install, reverse the removal procedure.